How to check gasoline: as long as you work hard to check whether the fuel meter is at the end of the year.
Note: don't let your oil come. The current new car in the mining electric gasoline pump rod and oil electronic sensor should be soaked in gasoline for heat dissipation. In addition, the low oil volume may also affect the exhaust system of the oxygen sensor. These parts are not cheap, so do not exceed the baseline fuel.
How to check the oil: only a few days to pull out the oil gauge, wipe, insert, and then pull out to see whether the oil level is between the upper and lower limit values.
Note: in general, the fuel consumption is not serious enough to pass the maintenance cycle, but the fuel consumption will be higher than usual in hot summer. If impurities or gasoline smell are found in the engine oil during the daily inspection, and the exhaust smoke is light blue, it indicates that the engine is faulty, the components may be abnormally worn, and the engine can enter the factory for maintenance quickly.
How to check the transmission oil: when you change the engine oil, you can check your transmission oil, because the inspection process is complicated, so you can ask the dealer's service department to deal with it. During measurement, the trolley must be put into neutral position P, idling speed, and parked on the flat ground. The oil temperature must reach 80 ℃ ~ 93 ℃. Note: too much or too little oil will damage the transmission. Too much oil may cause too much running resistance of parts, or make the oil bubble of gearbox deteriorate, resulting in abnormal wear of parts. So when you check the transmission oil, be sure to measure it.
(4) How to check the oil in the power direction: when the engine cools down, wipe the oil cover and the oil reservoir clean, and then screw the oil cap in the direction of unscrewing, wipe the oil dipstick clean with no fiber cleaning paper towel, and then install the lock, lock, and then open the surface of the oil dipstick to check. Note: when filling or changing the oil, the correct oil must be used according to the power direction. Improper use can damage the engine.
How to check the brake oil: just open the engine cover and check the liquid level of the brake oil tank, as long as it is not lower than the lower limit. Note: when the brake oil level is not checked, do not add brake oil to avoid too much, so that the brake oil will spray on the engine at high temperature, causing corrosion or even fire. If there are bubbles in the brake oil, or the oil becomes dirty, and the brake oil has deteriorated, please replace it as soon as possible, so as to avoid reducing the boiling point of the brake oil and foaming, resulting in poor braking effect, which is very dangerous.